How to measure custom-made cabinets: a hot topic and practical guide on the Internet
Recently, the topic of home decoration has continued to heat up, especially the size measurement method of custom-made cabinets has become a hot search topic. Many users reported that inaccurate dimensional measurements caused problems such as excessive gaps or inability to fit the cabinets after installation. This article will combine the hot discussions on the Internet in the past 10 days to provide you with structured data and detailed steps to help you easily customize your cabinets.
1. Top 5 popular cabinet customization topics on the entire network (last 10 days)
| Ranking | Topic keywords | search volume index | Main pain points |
|---|---|---|---|
| 1 | Cabinet size measurement error | 187,000 | Wall corners are not at right angles causing gaps |
| 2 | Kitchen water and electricity positioning | 152,000 | Socket conflicts with cabinet |
| 3 | Cabinet depth standard | 129,000 | Range hood installation does not match |
| 4 | Corner cabinet measurement method | 98,000 | Installation of rotating basket failed |
| 5 | Wall cabinet height calculation | 74,000 | Hit or out of reach |
2. 6 steps to accurately measure cabinet dimensions
Step 1: Sketch the kitchen floor plan
Use a tape measure to measure the total length of the wall, mark the locations of doors and windows, and record the dimensions of pipes, flues and other obstacles. The error must be controlled within ±3mm.
Step 2: Measurement of key locations (key data)
| Measurement part | Standard size | Things to note |
|---|---|---|
| Base cabinet depth | 550-600mm | Including protruding part of table top |
| Wall cabinet depth | 300-350mm | Need to avoid range hood |
| Operating table height | Height/2+50mm | Requires on-site simulation operation |
| Aisle width | ≥900mm | Double kitchen requires 1200mm |
Step 3: Special Area Treatment
When measuring corners, use the diagonal measurement method to record the verticality of the two walls. If it is found that the angle of the wall corner is not 90°, the deviation value must be clearly marked on the drawing.
3. Solutions to high-frequency problems
| Problem phenomenon | Cause of occurrence | solution |
|---|---|---|
| The seams on the countertop are obvious | The wall is uneven | Pre-embedded 5mm adjustment margin |
| Door panel does not open and close smoothly | Hinge hole position offset | Using three-dimensional coordinate measurement method |
| Difficulty embedding electrical appliances | No heat dissipation space is considered | Reserve ≥50mm all around |
4. Professional advice
It is recommended to use a laser rangefinder when measuring. Compared with the traditional tape measure, the accuracy is improved to ±1mm. Data from popular brands show that using professional tools can increase the first-time success rate of cabinet installation from 68% to 93%.
5. Measurement timing selection
The best measurement time is:
1. 3 days after the completion of wall tile laying
2. The ground leveling layer is completely dry.
3. The ceiling keels are installed
Avoid taking measurements on rainy days as changes in humidity may cause data distortion.
Through the above structured data and practical steps, you can not only avoid 90% of common measurement errors, but also obtain accurate data for communication with professional designers. It is recommended to use the naming rule of "date+location+measurer" when saving measurement data to facilitate later tracing.
check the details
check the details
en
